Comtech EF Data VMS v3.12.x Vipersat - Manual (Page 166)

Network Manager Configuration MN/22156, rev 12
3-66 VMS User Guide
Observe the Status of this reservation that is displayed in the far right
column of the table; the Inactive label should change to Active, indicating
that the reservation was accepted, as shown in figure 3-74.
Figure 3-74 Bandwidth Reservation Applied
If the attempt was not accepted, the label Unavailable will be displayed,
followed by information explaining the error—insufficient bandwidth
available, or insufficient hardware (expansion demod) available.
6. Should an error occur with this reservation, correct the mis-configuration
that caused the error, then re-apply the reservation.
Note that the reservation can be Activated or Inactivated as desired by checking
or unchecking the satellite and clicking Apply.
7. If forward path switching is enabled for this Remote, repeat steps 1 through 6
for configuring the InBand Rx Reservations.
8. Close the Properties window for this Remote.
9. Open the Satellite Reservations window to view the currently assigned (per
individual remote, and total) and available bandwidth for reservations on this
satellite (figure 3-75 and figure 3-76).