Comtech EF Data VMS v3.12.x Vipersat - Manual (Page 364)

SNMP Modem Manager MN/22156, rev 12
7-8 VMS User Guide
Parameter View
When a modem unit is selected from the tree list in the left ViperView window
panel, the right window panel displays the Parameter View, shown in
figure 7-6, that presents parameter setting information and options available for
the unit. This applies to the Modem as well as the Modulator and/or Demodula-
tor that are nested below it. Refer to each unit’s documentation for detailed
information on setting or changing any of the parameters listed here.
Figure 7-6 Parameter View, Drop-down Menu
A set of commands is presented in the Parameter View drop-down menu
(figure 7-6):
• Apply – Clicking the Apply command writes any changes made to the
unit’s configuration in the Parameter View to the unit’s active memory.
In order to make the changes permanent, these changes must be saved to
the unit’s flash memory.
• Revert – To discard any changes and return the parameter(s) to the
previous setting(s), click the Revert command to revert the setting(s) back
to the original configuration.
Note: If the changed parameter has been marked with the Dirty Selected
command (see below), the Revert command will not function.
NOTE