Comtech EF Data VMS v3.12.x Vipersat - Manual (Page 362)

SNMP Modem Manager MN/22156, rev 12
7-6 VMS User Guide
Figure 7-3 New SNMP Modem dialog
3. Configure the parameter settings for the new modem:
a. Enter the assigned IP Address for this modem (in this case, the CiM-25
address).
b. Enter the Subnet Mask in the designated field.
c. Assign a name to the modem in the next field for reference purposes and
for identification in ViperView.
d. Ensure the SNMP Community settings are correct.
For a CDM-600/L, the Read and Write Communities are admin1234.
For all other units, the Read Community is Public and the Write
Community is Private (defaults).
4. Click the OK button.
The unit will now appear listed in the SNMP Modem Manager. Select the
manager to see the modem appearance in the right panel of the ViperView
window.
5. To perform edits to a declared modem, right-click on the newly added unit
and select Properties from the drop-down menu. The Unit Properties
dialog will be displayed, as shown in figure 7-4.
If the modem is connected to a BUC, LNB, or other device, select the
Enable Radio Devices check-box to have this configuration recognized by
the VMS.