Texas Instruments TMS320C3x - Manual (Page 131)

Floating-Point Multiplication
5-26
5.5 Floating-Point Multiplication
A floating-point number
α
can be written in floating-point format as in the following
formula, where
α
( man) is the mantissa and
α
( exp) is the exponent:
α
=
α
( man)
×
2
α
( exp)
The product of
α
and b is c, defined as:
c =
α ×
b =
α
( man)
×
b(man)
×
2 (
α
( exp) + b (exp))
thus:
c(man) =
α
( man)
×
b(man)
c(exp) =
α
( exp) + b(exp)
During floating-point multiplication, source operands are in the single-precision
floating-point format. If the source operands are in short floating-point format,
they are converted to single-precision floating-point format. If the source oper-
ands are in extended-precision floating-point format, they are truncated to
single-precision format. These conversions occur automatically in hardware
with no overhead. All results of floating-point multiplications are in the extended-
precision format. These multiplications occur in a single cycle.
Figure 5–16 is a flowchart that shows the steps involved in floating-point multi-
plication. Each step is labelled with a number in parenthesis.
- In step 1, the 24-bit source operand mantissas are multiplied, producing
a 50-bit result
c(man). (Input and output data are always represented as
normalized numbers.)
- In step 2, the exponents,
α
( exp) and b(exp), are added, yielding c(exp).
- Step 3 checks for whether c(man) in extended-precision format is equal to
0. If c(man) is 0, step 7 sets c(exp) to –128, thus yielding the representation
for 0.
- Steps 4 and 5 normalize the result.
- If a right shift of 1 is necessary, then in step 8, c(man) is right-shifted one
bit, thus adding 1 to c(exp).
- If a right shift of 2 is necessary, then in step 9, c(man) is right-shifted two
bits, thus adding 2 to c(exp). Step 6 occurs when the result is normalized.
- In step 10, c(man) is set in the extended-precision floating-point format.
- Steps 11 through 16 check for special cases of c(exp).