Yaskawa Z1000U HVAC Matrix Bypass - Manual (Page 305)

A.4 Bypass Options
This following configurations are available for the bypass.
u Option B
Three-contactor bypass: Isolates the drive circuit by adding a separate drive input contactor.
u Option D
Ethernet/IP option.
u Option G
Drive Input Disconnect Switch: Provides a disconnect means for the input side of the drive for drive isolation capability during
bypass operation. This disconnect is located inside the enclosure with an integral operating handle.
u Option K (Control)
200 VA Control Power Transformer.
u Option K (Power)
Output Reactor 5%: Provides additional output impedance for long lead lengths or noise reduction.
u Option L
Serial Communication, Echelon LonWorks: An isolated circuit board provides LonTalk protocol for network communication
to a BAS. This option plugs into the CN5 connection on the bypass control circuit board.
u Option N
EMC Filter: Integral EMC Filter supplied with drive.
u Option W (Control)
Custom Nameplate: Provides a custom nameplate for placement on the front of the bypass.
u Option W (Power)
Soft Start Bypass: Provides a solid-state soft-starter with adjustable ramp to reduce mechanical system stress typically
associated with across-the-line bypass motor starts.
u Option Z
Speed Pot: Door-mounted speed control.
A.4 Bypass Options
YASKAWA SIEP YAIZ1D 01A Z1000U HVAC MATRIX Drive Bypass Technical Manual 305
A
Specifications