Festo Электромотор MTR-DCI - Manual (Page 121)

5. Commissioning
5-23
Festo P.BE-MTR-DCI-DN-EN en 1209a
5.3 Commissioning with FCT
The Festo Configuration Tool (FCT) is the software platform for
configuring and commissioning different components and
devices from Festo.
The FCT consists of the following components:
– A framework as program start and entry point with uni-
form project and data management for all supported
types of devices,
– A plug-in for the special demands of each device type
(e.g. MTR-DCI) with the necessary descriptions and dia-
logues. The plug-ins are managed and started from the
framework.
The MTR-DCI plug-in for the Festo Configuration Tool supports
all the steps necessary to commission an MTR-DCI. With the
MTR-DCI plug-in for the Festo Configuration Tool the
necessary parameter settings can be performed offline - that
is, without connecting the MTR-DCI to the PC. This enables
the actual commissioning procedure to be prepared in
advance, such as in the design office when planning a plant
setup.
5.3.1 Installing the FCT
The FCT is installed on your PC with an installation program.
The MTR-DCI plug-in is installed on your PC together with the
FCT's installation program.
Note
Administrator rights are required for installing the FCT.