Festo Электромотор MTR-DCI - Manual (Page 77)

4. The control panel (type MTR-DCI-...-H2 only)
4-3
Festo P.BE-MTR-DCI-DN-EN en 1209a
The control panel of motor unit MTR-DCI-...- H2 enables com-
missioning directly on the MTR-DCI. An overview of the key
and menu functions can be found in this chapter.
Commissioning with the control panel is described from
chapter 5.2 .
With the MTR-DCI-...- R2 (without control panel) you can com-
mission the MTR-DCI via the RS232 interface (with FCT soft-
ware). Instructions on this can be found in chapter 5.3.
Caution
Simultaneous access of control functions and operating
functions by the FCT and the control panel can cause
faults.
• Make sure that FCT and the control panel are not in use
at the same time.
• If necessary, utilise the facility to disable parameterisa-
tion and positioning functions from the control panel
(HMI Access, see section 5.5.2).
Note
Remove the protective film from the display, if still fitted,
before using it for the first time.