Festo Электромотор MTR-DCI - Manual (Page 17)

Contents and general safety instructions
XV Festo P.BE-MTR-DCI-DN-EN en 1209a
About the version
The hardware version specifies the version status of the
mechanical parts and electronics of the MTR-DCI. The firm-
ware version indicates the version status of the MTR-DCI's
operating system.
You can find the version specifications as follows:
– Hardware version and firmware version under “Device
data” in the Festo Configuration Tool with active device
connection to the MTR-DCI
– Firmware version on the control panel under [Diagnostic]
[Software information]
Firmware
version What is new ? Which FCT plug-in ?
V1.00 Supports the listed sizes of the MTR-DCI-DN in combina-
tion with the following Festo axes:
Motor unit
Axes
MTR-DCI-32... DMES-18; DNCE-32
MTR-DCI-42... DMES-25; DNCE-32/40
MTR-DCI-52... DMES-40; DNCE-40/63
MTR-DCI-62... DMES-63; DNCE-63
MTR-DCI-DN V2.1.0
Table 0/2: Firmware versions