Festo Электромотор MTR-DCI - Manual (Page 195)

6. Diagnosis and error display
6-5
Festo P.BE-MTR-DCI-DN-EN en 1209a
6.2 LED status displays
1
Power LED
2
I/F LED
3
Error LED
1 2 3
Fig. 6/1: LEDs on the control panel of the MTR-DCI-...
POWER GREEN Power supply
ON Load and logic voltages applied.
FLASH-
ING Logic voltage is applied.
Load voltage is
not applied.
OUT No voltage is applied.
Tab. 6/3: “Power” LED
ERROR RED Fault display
ON Fault. Device not ready for operation. Check
cause and rectify if necessary; see sec-
tion 6.3.
FLASH-
ING Warning. Check cause and rectify if
necessary; see section 6.3.
OUT No internal fault reported.
Tab. 6/4: “Error” LED