Festo Электромотор MTR-DCI - Manual (Page 27)

1. System overview
1-5 Festo P.BE-MTR-DCI-DN-EN en 1209a
All values are entered and displayed according to the confi-
gured units of measurement.
Units of measurement Control
panel FCT Field bus
Linear axis Metric Metric units,
e. g. mm, mm/s, mm/s
2
x x –
Inches
1)
Imperial units,
e. g. inch, inch/s, inch/s
2
– x –
Increments Increment-based measuring
units, e. g. inc, inc/s, inc/s
2
– – x
Rotational
axis Degrees Angular measurement
360° = 1 revolution
e. g. deg, deg/s, deg/s
2
x x –
Revolutions
2)
Number of revolutions
e. g. rev, rev/min, rev/min
2
x – –
Increments Increment-based measuring
units, e. g. inc, inc/s, inc/s
2
– – x
1)
Only with FCT when setting up a project.
2)
Setting only with the control panel [Settings] [Axis type] [Rotation axis]
The setting for the units of measurement influences only the
display. In the controller all parameters are always saved in
increment specifications (inc, inc/s, inc/s
2
...) and not con-
verted until they are written or read.
Measurements transmitted via Fieldbus or RS232 are based
on increments (for conversion see appendix A.4).