Festo Электромотор MTR-DCI - Manual (Page 122)

5. Commissioning
5-24
Festo P.BE-MTR-DCI-DN-EN en 1209a
Note
As of version V2.1.0, the plug-in MTR-DCI supports the
following motor units:
– MTR-DCI-...-DN: firmware version V1.00 and higher
• Check with later versions of the MTR-DCI to ascertain
whether an updated plug-in is provided. If necessary
consult Festo.
1. Close all programs.
2. Place the Festo Configuration Tool CD in your CD ROM
drive. If Auto Run is activated on your system, the installa-
tion will start automatically and you can omit steps 3
and 4.
3. Select [Run] in the Start menu.
4. Enter D:\setup (if necessary replace D by the letter of your
CD ROM drive).
5. Follow the instructions on the screen.
5.3.2 Procedure
Starting the FCT
1. Connect the MTR-DCI to your PC via the RS232 port.
Follow the instructions in section 3.4.
2. Start the FCT:
Double-click the FCT icon on the desktop
– or –
Select the entry [Festo Software] [Festo Configuration
Tool] in the Windows [Start] menu.
3. Create a project in the FCT or open an existing project.
Add a device to the project with the MTR-DCI plug-in.