Festo Электромотор MTR-DCI - Manual (Page 68)

3. Installation
3-12
Festo P.BE-MTR-DCI-DN-EN en 1209a
Information on commissioning and parameterising the
MTR-DCI via the serial interface can be found in chapter 5.3
and in the help system for the FCT software package.
Information on transmitting CI commands via the serial
interface can be found in appendix C.1.2.
Note
The RS232 communications port is not electrically isolated.
It is not suitable for permanent connection to PC systems,
nor for use as a control interface.
• Use this terminal only for commissioning.
• Remove the programming cable in continuous opera-
tion.
• Seal the connection with the protective cap supplied
(ISK-M8).