Festo Электромотор MTR-DCI - Manual (Page 242)

B. Reference – Festo DeviceNet and FHPP
B-20
Festo P.BE-MTR-DCI-DN-EN en 1209a
Data Memory Control
FHPP 127 1, 2 Array uint8 rw 1)
Description Commands for the EEPROM (non-volatile data storage)
Delete EEPROM 127 1 uint8 rw
When the object has been written, and after Power Off/On, the data in the
EEPROM is reset to the factory settings.
Fixed: 16 (0x10): delete data in the EEPROM and restore factory settings.
Pay attention to the following note.
Save Data 127 2 uint8 rw
The data in EEPROM is overwritten with the current user-specific settings.
Fixed 1 (0x01): save data
CI 20F1h 01h, 02h Array uint8 rw 1)
DeviceNet 64h 01h 14h, 15h uint8 rw 1)
1) When reading the reply “0” always occurs
Note
All user-specific settings will be lost when the EEPROM is
deleted (except for the cycle number). The status after
deletion corresponds to the standard factory setting.
• Always carry out initial commissioning after deleting the
EEPROM.
• When the EEPROM is deleted, the field bus parameters
are also reset!