Festo Электромотор MTR-DCI - Manual (Page 111)

5. Commissioning
5-23
Festo P.BE-MTR-DCI-PB-EN en 1209a
5.3.1 Installing the FCT
Note
The plugin MTR-DCI V2.0.0 supports the following motor
units:
– MTR-DCI-...-PB: firmware version V1.00 and higher
• Check with later versions of the MTR-DCI to ascertain
whether an updated plugin is provided. If necessary
consult Festo.
Note
Administrator rights are required for installing the FCT.
The FCT is installed on your PC with an installation program.
The MTR-DCI plugin is installed on your PC together with the
FCT's installation program.
1. Close all programs.
2. Place the Festo Configuration Tool CD in your CD ROM
drive. If Auto Run is activated on your system, the installa-
tion will start automatically and you can omit steps 3
and 4.
3. Select [Run] in the Start menu.
4. Enter D:\setup (if necessary replace D by the letter of your
CD ROM drive).
5. Follow the instructions on the screen.