Festo Электромотор MTR-DCI - Manual (Page 146)

5. Commissioning
5-58
Festo P.BE-MTR-DCI-PB-EN en 1209a
6. Direct mode: Position mode
(requires status 1.3/2.3 and 4.)
Step/
Description Control bytes Status bytes
Byte B7 B6 B5 B4 B3 B2 B1 B0 Byte B7 B6 B5 B4 B3 B2 B1 B0
6.1 Preselect position
and speed
(control bytes 4 and
5...8) Byte 4 RVelocity Byte 4 RVelocity
Speed Speed preselection
(0...100 %)
Speed Speed response message
(0...100 %)
Byte 5...8 Position Byte 5...8 Position
Nom-
inal
posi-
tion Nominal position (increments) Ac-
tual
posi-
tion Actual position (increments)
6.2 Start positioning
task Byte 1 OPM2 OPM1 LOCK – RESET BRAKE STOP ENABL Byte 1 OPM2 OPM1 LOCK 24VL FAULT WARN OPEN ENABL
CCON 0 1 x x 0 x 1 1 SCON 0 1 0 1 0 0 1 1
Byte 2 – CLEAR TEACH JOGN JOGP HOM START HALT Byte 2 REF STILL DEV MOV TEACH MC ACK HALT
CPOS x 0 0 0 0 0 F 1 SPOS 1 0 0 0 0 0 1 1
Byte 3 FUNC FAST XLIM VLIM CONT COM2 COM1 ABS Byte 3 FUNC FAST XLIM VLIM CONT COM2 COM1 ABS
CDIR 0 0 0 0 0 0 0 S SDIR 0 0 0 0 0 0 0 S
6.3. Positioning task
in progress Byte 1 OPM2 OPM1 LOCK – RESET BRAKE STOP ENABL Byte 1 OPM2 OPM1 LOCK 24VL FAULT WARN OPEN ENABL
CCON 0 1 x x 0 x 1 1 SCON 0 1 0 1 0 0 1 1
Byte 2 – CLEAR TEACH JOGN JOGP HOM START HALT Byte 2 REF STILL DEV MOV TEACH MC ACK HALT
CPOS x 0 0 0 0 0 1 1 SPOS 1 0 0 1 0 0 1 1
6.4 Positioning task
concluded Byte 1 OPM2 OPM1 LOCK – RESET BRAKE STOP ENABL Byte 1 OPM2 OPM1 LOCK 24VL FAULT WARN OPEN ENABL
CCON 0 1 x x 0 x 1 1 SCON 0 1 0 1 0 0 1 1
Byte 2 – CLEAR TEACH JOGN JOGP HOM START HALT Byte 2 REF STILL DEV MOV TEACH MC ACK HALT
CPOS x 0 0 0 0 0 0 1 SPOS 1 0 0 0 0 1 0 1
0: 0-signal; 1: 1-signal; x: not relevant (any); F: Edge positive
S: Positioning condition: 0= absolute; 1 = relative
Tab. 5/14: Control and status bytes for “Positioning by Direct Mode”