Festo Электромотор MTR-DCI - Manual (Page 25)

1. System overview
1-5 Festo P.BE-MTR-DCI-PB-EN en 1209a
All parameters are input or displayed corresponding to the
set units of measurement.
Units of measurement Control
panel FCT Profibus
Linear axis Metric Metric units of measurement,
e.g. mm, mm/s, mm/s
2
x x –
inch
1)
Imperial units of
measurement, e.g. inch,
inch/s, inch/s
2
– x –
Increments Increment-based units of
measurement, e.g. inc, inc/s,
inc/s
2
– – x
Axis of
rotation Degree Angular dimensions
360° = 1 revolution
e.g. deg, deg/s, deg/s
2
x x –
Revolutions
2)
Number of revolutions
e.g. rev, rev/min, rev/min
2
x – –
Increments Increment-based units of
measurement, e.g. inc, inc/s,
inc/s
2
– – x
1)
Only with FCT when creating a project.
2)
Setting only with the control panel [Settings] [Axis type] [Rotation axis]
The setting of the units of measurement influences only the
display. All the parameters in the controller are saved intern-
ally in increments (inc, inc/s, inc/s
2
...) and are not converted
until they are written in or read.
Dimensions transmitted via PROFIBUS or RS232 are based on
increments (for conversion see appendix A.4).