Festo Электромотор MTR-DCI - Manual (Page 15)

Contents and general safety instructions
XIII Festo P.BE-MTR-DCI-PB-EN en 1209a
About the version
Hardware version Specifies the version status of the mechanical parts and elec-
tronics of the MTR-DCI.
Firmware version Specifies the version status of the operating system of the
MTR-DCI.
You can find the version specifications as follows:
– Hardware version and firmware version under “Device
data” in the Festo Configuration Tool with active device
connection to the MTR-DCI.
– Firmware version on the control panel under [Diagnostic]
[Software information]
Firmware
version What is new ? Which FCT plugin ?
V1.00 and
higher Supports the listed sizes of the MTR-DCI-PB in combina-
tion with the following Festo axes:
Motor unitAxes
MTR-DCI-32...
DMES-18; DNCE-32
MTR-DCI-42... DMES-25; DNCE-32/40
MTR-DCI-52... DMES-40; DNCE-40/63
MTR-DCI-62... DMES-63; DNCE-63
MTR-DCI V2.0
Tab. 0/2: Firmware versions