Festo Электромотор MTR-DCI - Manual (Page 73)

4. The control panel (type MTR-DCI-...-H2)
4-7
Festo P.BE-MTR-DCI-PB-EN en 1209a
Menu command Description
} Diagnostic Displays the system data and the currently effective settings
(see section 4.3)
} Pos. set table Displays the position set table
} Axis parameter Displays axis parameters and data
} System paramet Displays system parameters and system data
} PROFIBUS Diag Displays PROFIBUS diagnosis data
} SW information Displays the operating system version (firmware)
} Positioning 1) 2) Homing and positioning runs for testing the position set records (see section 4.5)
} Move posit set Starts the positioning run for “position set record”
} Demo posit tab Starts the positioning run for “position set table”
} Homing Starts the homing run
} Settings 1) 2) Selection of the drive, parameter assignment, programming the position set records...
(see section 4.4)
} Axis type } Type DMES-... Valve actuator DMES-...
} Type DNCE-... Electric cylinder DNCE-...
} Rotation drive Rotational axis with stop
} User config Any linear drive
} Axis parameter } Zero point 3) Offset of axis zero point
} Abs.min.pos 3) Stroke limitation: software end position, negative
} Abs.max.pos 3) Stroke limitation: software end position, positive
} Save... Saves parameters in EEPROM
} Homing
paramet
} Homing method Selection of reference travel method (stop, software limit switch...)
} Velocity v_sw Positioning speed for searching for the homing point
} Velocity v_s0 Positioning speed for moving to the axis zero point
} Save... Saves parameters in EEPROM
} Position set } Position nr. Number of the position set record (0...31)
} Pos set mode Absolute or relative positioning
} Position 3) Target position of the position set record
} Velocity Positioning speed of the position set record
} Save... Saves parameters in EEPROM
} Password edit Sets up a local password with 3 digits for the control panel (see section 4.4).
} PB Parameter Sets the PROFIBUS address
} HMI control 1) Presetting for device control via the control panel (see section 4.6)
} LCD adjustment Rotates the display in steps of 90°
1) May be password-protected 3) Teach mode
2) Control interface must be deactivated; see [HMI control] :HMI = on
Tab. 4/3: Menu commands (overview)