Festo Электромотор MTR-DCI - Manual (Page 88)

4. The control panel (type MTR-DCI-...-H2)
4-22
Festo P.BE-MTR-DCI-PB-EN en 1209a
4.6 Menu command [HMI control]
To select the menu commands [Positioning] and [Settings]
you require the setting “HMI: on”. Only then is the MTR-DCI
ready to process user entries on the control panel. When se-
lecting the menu commands, you will be prompted to modify
the HMI setting.
[HMI control] You can also modify the setting directly with the menu com-
mand [HMI control].
HMI
1)
Device control
on Device control is carried out manually via the control
panel. The control interface of the MTR-DCI is deactivated
and control enable is set. The actual status of the ENABLE
control bit then has no effect.
off Device control is carried out via the control interface of
the MTR-DCI.
1)
Human Machine Interface
Note
Access to the MTR-DCI via HMI and FCT can be blocked via
the fieldbus (“HMIAccess locked”).