Festo Электромотор MTR-DCI - Manual (Page 213)

B. Supplementary information
B-7
Festo P.BE-MTR-DCI-PB-EN en 1209a
Fault numbers Description
0 0x00 Invalid PNU. The parameter does not exist.
1 0x01 Parameter value cannot be modified (read only)
(2) 0x02 – (Reserved - lower or upper limit value exceeded) 1)
3 0x03 Faulty subindex
4 0x04 No array
5 0x05 Incorrect data type
(6) 0x06 – (Reserved - setting not permitted – can only be reset) 1)
(7) 0x07 – (Reserved - description element cannot be modified) 1)
(8) 0x08 – (Reserved - PPO-Write requested in IR does not exist) 1)
9 0x09 Description data does not exist
(10) 0x10 – (Reserved - access group incorrect) 1)
11 0x0A No control signals accepted
(12) 0x0B – (Reserved - password incorrect) 1)
13 0x0C Text cannot be read in cyclical exchange
(14) 0x0D – (Reserved - name cannot be read in cyclical exchange) 1)
(15) 0x0E – (Reserved - text array does not exist) 1)
(16) 0x10 – (Reserved - PPO-Write missing) 1)
(17) 0x11 – (Reserved - request cannot be processed because of operating status) 1)
(18) 0x12 – (Reserved - other faults) 1)
(19) 0x13 – (Reserved - data cannot be read in cyclical exchange) 1)
(20) 0x14 – (Reserved - invalid value) 1)
(21) 0x15 – (Reserved - response too long) 1)
22 0x16 Invalid: attributes, number of elements, PNU or IND
(23) 0x17 – (Reserved - write request: invalid format) 1)
24 0x18 Write request: number of values is invalid
(...99) 0x64 – (Reserved - PROFIBUS)
100 0x65 – (Reserved - Festo: ReqID is not supported) 1)
(...255) 0xFF – (Reserved - Festo)
1) These fault numbers are not used