Festo Электромотор MTR-DCI User Manual
Page 230
B. Supplementary information
B-24
Festo P.BE-MTR-DCI-PB-EN en 1209a
Data Memory Control
PNU
127
1...2
0...1
uint8
wo
Description
Commands for the EEPROM (non-volatile data storage)
Delete EEPROM 127
1
0
When the object has been written and after Power Off/On, the data in the
EEPROM is reset to the factory settings.
Fixed: 16 (0x10): delete data in the EEPROM and restore factory settings.
Save Data 127
2
1
The data in EEPROM is overwritten with the current user-specific settings.
Fixed 1 (0x01): save data.
CI access
20F1h
01h...02h
uint8
wo
Note
All user-specific settings will be lost during deletion
(except for cycle number). The status after deletion cor-
responds to the standard factory setting.
•
Always carry out initial commissioning after deleting the
EEPROM.
•
The settings of the LCD parameters are lost when the
EEPROM is deleted and may need to be set again. The
LCD display remains dark if the parameter setting is not
correct.
•
When the EEPROM is deleted, the fieldbus address is
also reset.