Festo Электромотор MTR-DCI - Manual (Page 69)

4. The control panel (type MTR-DCI-...-H2)
4-3
Festo P.BE-MTR-DCI-PB-EN en 1209a
Motor unit MTR-DCI-...- H2 offers all functions required for
commissioning, programming and diagnostics on the control
panel. An overview of the key and menu functions can be
found in this chapter.
Commissioning with the control panel is described from
chapter 5.2 onwards.
With the MTR-DCI-...-
R2 (without control panel), you can
execute commissioning of the MTR-DCI via the RS232 inter-
face (with FCT software). Instructions on this can be found in
chapter 5.3.
Caution
Simultaneous access of control functions and operating
functions by the FCT and the control panel can cause
faults.
• Make sure that FCT and the control panel are not in use
at the same time.
Note
If necessary, remove the protective film from the display
before commissioning.