Festo Электромотор MTR-DCI - Manual (Page 180)

6. Diagnostics and fault display
6-8
Festo P.BE-MTR-DCI-PB-EN en 1209a
Cat-
egory Status
bytes
2)
Fault
LED Fault
number Device
Error
1)
Description Name, display
Fault PLEASE ENFORCE
HOMING RUN! Not referenced
(homing not carried
out) 0x0200 1 ON FAULT
Warning STANDSTILL-
WARNING Standstill
monitoring 0x4000 36 FLASH-
ING WARN,
STILL
Fault PROFIBUS-INIT-
ERROR Hardware
initialisation fault 0x8000 51 ON FAULT
Warning HOT TEMPERATURE Temperature
too high – – FLASH-
ING WARN
Warning COLD
TEMPERATURE Temperature
too low – – FLASH-
ING WARN
1) See object 2FF1/00
2) For FHPP status bytes, see section 5.7.2
Tab. 6/7: Faults and warnings with fault numbers and fault bits
6.3.2 Description of faults and warnings
Messages Messages give information regarding operating states.
Message Cause
Attention!
Motor moves... Message before the start of a positioning move-
ment. After confirmation with the <ENTER> button,
the drive starts moving.
Profile velocity
= 0. Please set
v. The menu command [Move position set] is not
being executed because the positioning speed
of the position set record is v = 0. Modify the
parameter assignment or select a different
position set record.