Festo Электромотор MTR-DCI - Manual (Page 82)

New Password:
[?xx] =
ESC <Menu>
EDIT <--> OK <Enter>
Enter Password:
[?xx] =
ESC <Menu>
EDIT <--> OK <Enter>
4. The control panel (type MTR-DCI-...-H2)
4-16
Festo P.BE-MTR-DCI-PB-EN en 1209a
Setting a password
In order to prevent unauthorised or unintentional overwriting
or modification of parameters in the device, access via the
control panel can be protected by a “local” password. No
password has been preset at the factory (presetting = 000).
[Password] Select [Settings] [Password] in the menu:
Enter a password with 3 digits. The current entry position is
marked with a question mark.
1. Use the arrow buttons to select a digit 0...9.
2. Confirm your entry with <Enter>. The next entry position
will be displayed.
3. After entering the third digit, save your setting with SAVE
<Enter>.
Entering a password
As soon as a password is active, it will be scanned automati-
cally when the menu commands [Positioning], [Settings] or
[HMI control] are accessed. When the correct password is
entered, all parameterising and control functions of the con-
trol panel are enabled until the power supply is switched off.
The current entry position is marked with a question mark.
1. Use the arrow buttons to select a digit 0...9.
2. Confirm your entry with <Enter>. The next entry position
will be displayed.
3. Repeat the entry for the remaining entry positions.
Once the third digit has been confirmed, access via the
control panel is enabled.