2 procedure, Procedure – Festo Контроллеры двигателя SFC-LAC User Manual
Page 128
5. Commissioning
5−26
Festo GDCP−SFC−LACI−CO−EN en 0812NH
5.3.2
Procedure
Starting the FCT
1. Connect the SFC−LACI to your PC via the parameterising
interface (RS232),
} chapter 3.5.
2. Start the FCT:
Double click on the FCT icon on the desktop
ć or ć
Switch to Windows and select the entry [Festo Software]
[Festo Configuration Tool] in the menu [Start].
3. Create a project in the FCT or open an existing project.
Add a device to the project with the SFC−LAC plug−in.
Instructions on parameterising and commissioning
FCT framework
Information on working with projects and on inserting a
device in a project can be found in the help for the FCT
framework with the command [Help] [Contents FCT general].
Plug−in SFC−LAC
The SFC−LAC plug−in for the FCT supports all the steps neces−
sary for commissioning an SFC−LACI. The necessary param−
eterisation can be executed offline, i.e. without the SFC−LACI
being connected to the PC. This enables preparation for the
actual commissioning, e.g. in the design office when a new
system is planned.
Further information can be found in the plug−in help:
Command [Help] [Contents of installed plug−ins] [Festo (manuĆ
facturer name)ā] [SFC−LAC (plug−in name)ā].