B.3 reference fhpp parameters (pnu), B.3.1 parameter groups, Reference fhpp parameters (pnu) – Festo Контроллеры двигателя SFC-LAC User Manual
Page 247: B−19, B.3.1, Parameter groups
B. Parametrising as per FHPP−FPC
B−19
Festo GDCP−SFC−LACI−CO−EN en 0812NH
B.3
Reference FHPP parameters (PNU)
B.3.1
Parameter groups
Group
PNU
Description
Device data
100..199
Device identification and device−specific settings,
version numbers, identifier words, etc.
Diagnostic memory
200...299
Memory for diagnostic events: fault numbers, fault time,
incoming/outgoing event
Process data
300...399
Current nominal and actual values, local I/Os, status
data etc.
Position set table
(= Record list)
400...499
A record contains all the setpoint value parameters
required for a positioning procedure.
Project data
500...599
Basic project settings. Maximum speed and acceleration,
project zero point offset, etc.
} These parameters form the basis of the position set
table.
Factor group
600...699
(reserved)
Axis data
Electric drives 1
1000...1099
All axis−specific parameters for electric drives. Gear factor,
feed constant, reference parameter, etc.
Axis data
Electric drives 2
1200...
Enhancements