Festo Контроллеры двигателя SFC-LAC User Manual
Page 19
Contents and general safety instructions
XVII
Festo GDCP−SFC−LACI−CO−EN en 0812NH
Term / abbreviation
Meaning
Logic 1
24 V present at input or output (positive logic, corresponds to HIGH).
MMI
Man Machine Interface". Corresponds to HMI.
PLC/IPC
Programmable logic controller/industrial PC
Positioning mode
(Profile position mode)
See overview of operating modes in section 1.1.4.
Positioning record
Positioning command defined in the position set table, consisting of
target position, speed, acceleration and other values.
PZ (= project zero point)
Project zero point. See section 1.1.5.
REF (= REFerence point)
Reference point. See section 1.1.5.
Reference switch
Proximity sensor used for defining the reference point.
The integrated homing switch must not be moved in DNCE−...−LAS and
DFME−...−LAS (exception: minimum offset as described in section 6.7).
Software end position
See overview of measuring reference system in section 1.1.5.
STOP
With a STOP signal a running positioning movement is interrupted:
The drive stops, the positioning record counts as concluded. See HALT.
Teaching
Accept an actual position in the position set table, or as axis zero point,
project zero point, or software end point. The desired position can be
approached in jog mode.
Tool mass
(tool load)
For example: the mass of a gripper attached to the piston rod (or the
front plate) of the drive (including mounting elements). The tool load
applies to all positioning records, see Fig. 0/1
Tab. 0/1: Index of terms and abbreviations