Festo Контроллеры двигателя SFC-LAC - Manual (Page 95)

4. The control panel (only type SFC−LACI−...−H2−...)
4−13
Festo GDCP−SFC−LACI−CO−EN en 0812NH
4.5 [Settings] menu
For parameterising the axis system and the positioning
records:
1. Select the entry [Settings] in the main menu. <ENTER>
2. Select a menu command. <ENTER>
[Settings] Description Section
[Axis type] The axis controlled by the SFC−LACI 4.5.1
[Axis parameter] Teach mode for setting the axis parameters 4.5.2
[Homing paramet.] Setting the homing method and the speed during homing 4.5.3
[Position set] Teach mode for programming the position set table 4.5.4
[Jog mode] Jog mode: Continuous manual travel 4.5.5
[CO parameter] Setting the fieldbus parameters 4.5.6
[Password edit] Setting up a password for the control panel 4.5.7
Tab. 4/5: [Settings] menu
Note
The set parameters take effect immediately after confirmaĆ
tion with OK <ENTER>.
· Use [SAVE...] to permanently save the settings in
EEPROM. Only then will the settings be retained even
after switching off the power supply or in the event of
a power failure.
} Settings
Axis type
Axis parameter
Homing paramet.
Position set
Jog mode
CO parameter
Password edit