Festo Контроллеры двигателя SFC-LAC - Manual (Page 120)

5. Commissioning
5−18
Festo GDCP−SFC−LACI−CO−EN en 0812NH
Note
If the axis zero point is modified:
Existing software end positions and the target positions in
the position set table will be shifted together with the axis
zero point.
· Teach the software end positions and the target posiĆ
tions again if needed.
The project zero point PZ can only be set via FCT or PNUĂ500/
Object 21F4h.