Festo Контроллеры двигателя SFC-LAC - Manual (Page 17)

Contents and general safety instructions
XV Festo GDCP−SFC−LACI−CO−EN en 0812NH
Information on the version
The hardware version specifies the version status of the
mechanical and electronic components of the SFC−LACI.
The firmware version specifies the version status of the
operating system of the SFC−LACI.
You can find the specifications on the version status as folĆ
lows:
ć Hardware version and firmware version under Device
data" in the Festo Configuration Tool, when there is active
linkage to the SFC−LACI
ć Firmware version on the control panel under [Diagnostic]
[Software information].
Firmware
version
from What is newā? Which FCT plug−inā?
V 01.00 Motor controller with CANopen interface
Type SFC−LACI−...−CO, supports the following drives:
Ĉ DNCE−...−LAS
Ĉ DFME−...−LAS SFC−LAC V 03.00