Festo Контроллеры двигателя SFC-LAC - Manual (Page 106)

5. Commissioning
5−4
Festo GDCP−SFC−LACI−CO−EN en 0812NH
5.1 Preparations for commissioning
Warning
There is a danger of injury.
Electric axes can move suddenly with high force and at
high speed. Collisions can lead to serious injury to human
beings and damage to components.
· Make sure that nobody can reach into the operating
range of the axes or other connected actuators (e.g.Ăwith
a protective grille) and that no objects lie in the positionĆ
ing range while the system is still connected to a power
supply.
For commissioning, the mechanical system must be config−
ured and a measuring reference system must be defined
(see Tab. 1/1). The measuring system is used to define all
positions and they can be approached, for example, using
a positioning record from the position set table.
· Carry out parameterising and commissioning by means
of the control panel or FCT, as described in the following
chapters and in the FCT/plug−in help.
· Check the default settings in the [Diagnostic] menu.
· Upon completion of commissioning, note the instructions
for operation in the FCT/plug−in help and in section 5.7.