Festo Контроллеры двигателя SFC-LAC - Manual (Page 97)

4. The control panel (only type SFC−LACI−...−H2−...)
4−15
Festo GDCP−SFC−LACI−CO−EN en 0812NH
4.5.3 [Settings] [Homing parameters]
Setting the homing method and the speed during homing.
· Observe the instructions in chapter 5.2.2.
[Hom. paramet.] Param. Description
[Homing method] switch negative Homing to the integrated
reference switch at the
retracted end position with
index search
block negative Homing to a negative fixed
stop
block positive Homing to positive fixed
stop
Note: Further homing methods can only be
configured via FCT.
[Velocity v_rp] v_rp Speed for searching for the
reference point
[Velocity v_zp] v_zp Speed for moving to the
axis zero point
[SAVE...] Save parameters in EEPROM
Note
A new homing run must always be carried out after modi−
fying the homing method.
The maximum speed for homing is subject to built−in limits.