Festo Контроллеры двигателя SFC-LAC - Manual (Page 113)

5. Commissioning
5−11
Festo GDCP−SFC−LACI−CO−EN en 0812NH
CAN voltage supply (CAN volt. supply)
ć The following settings are possible: internal/external
ć Internal voltage supply is preset.
Note
This parameter becomes effective immediately (not after
switching on again or after a software reset).
Further information on the CAN voltage supply see
section 3.6, Tab. 3/8.
} Settings
CO parameter
CAN volt.supply
CAN volt.supply
internal
ESC <Menu>
EDIT <––> OK <Enter>