Festo Контроллеры двигателя SFC-LAC - Manual (Page 69)

3. Installation
3−17
Festo GDCP−SFC−LACI−CO−EN en 0812NH
Connection Pin Designation Function Fieldbus
plug
1)
1 5 1 n.c. Not connected ć
2 CAN_L CAN bus low A/L
6 9 3 5) CAN GND CAN bus reference potential GND
4 n.c. Not connected ć
5 Screened Capacitive connection to housing Clamping
strap
6 2)
5)
GND logic 3) Logic power GND (see Tab. 3/3) ć
5)
GND bus 4) Bus interface power supply
reference potential
7 CAN_H CAN bus high B/H
8 n.c. Not connected ć
9 2) n.c. 3) Not connected V+
24 V bus 4) Power supply to the bus interface
ć Screening/housĆ
ing Connection to (FE) functional
earth Clamping
strap
1) Pin assignment on fieldbus plug type FBS−SUB−9−BU−2x5POL−B from Festo
2) Depending on parameterisation CAN Voltage Supply" (see section 5.2.1) or [CAN Volt.Supply]
on control panel (see section 4.5.6, [CO parameters] ).
3) Internal supply of the fieldbus node (default): CAN bus (pins 2, 3, 7) referred to logic voltage of
the SFC−LACI.
· Do not connect pins 6 and 9.
4) External supply of the fieldbus node: CAN bus (pins 2, 3, 7) referred to external power supply
(permits electrically isolated bus connection).
· Pin 6 and pin 9 must be supplied with 24 V.
5) Pin 3 and pin 6 are connected internally with each other in the SFC−LACI−CO.
Tab. 3/8: I/F" terminal (control terminal) on the SFC−LACI−...−CO