Festo Контроллеры двигателя SFC-LAC - Manual (Page 111)

5. Commissioning
5−9
Festo GDCP−SFC−LACI−CO−EN en 0812NH
5.2.1 Setting the CAN bus parameters
· Switch the SFC−LACI on. During first commissioning or
when the EEPROM has been deleted, the fault message
CAN−BUS INIT NO PARAMETER ERROR" will appear.
In order to set the CAN bus parameters during first commisĆ
sioning or after deletion of the EEPROM:
· Select Config <Enter>.
In order to modify the CAN bus parameters when recommisĆ
sioning (i.e. if these parameters have already been comĆ
pletely parameterised):
· Select [Settings] [CO parameters] [...]
(see also section 4.5).
1. Select the desired CAN bus parameters with the arrow
keys (details: see next page).
2. Press <Enter> to display the current setting.
3. If necessary, modify the setting with the arrow keys.
4. Accept the setting with OK <Enter>. The setting is saved
against network failure.
Note
The set CAN bus parameters first become effective after
Power off/on" or after a software reset (object 20F1/03h/
PNU 127).
CAN–BUS INIT NO
PARAMETER ERROR
Diagnostic <Menu>
Config <Enter>
SFC–LACI...
D...
Xa = 0.00 mm
HMI:off
<Menu>