Lenze 8400 motec - Manual (Page 160)

5 Motor control (MCTRL)
5.11 Encoder/feedback system
160 Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Parameterisation dialog in the »Engineer«
Short overview of the relevant parameters:
General procedure
1. Configuring DI1 and DI2 as frequency inputs . ( 185)
2. Set the encoder increments in C00420/1 .
3. Select "1: Encoder signal FreqIn12" in C00495/1 .
4. Adapt the filter time of the speed measurement in C00497/1 .
Parameter Info Lenze setting
Value Unit
C00495 Speed sensor selection
• Source of feedback signal for speed control.
No sensor
C00420/1 Encoder increments at FreqIn12
• When the digital inputs DI1 and DI2 are used as
frequency input.
128 Inc/rev.
C00115/1 Fkt. DI 1/2 10kHz
• Function of the digital inputs DI1 and DI2
DI1=In1 | DI2=In2
C00497/1 Encoder filter time FreqIn12
• When the digital inputs DI1 and DI2 are used as
frequency input.
1.0 ms
C00496  Encoder evaluation method ( 161) Low-resolution encoder
C01206/1 Mounting direction: Motor not inverted
C01206/2 Mounting direction: Position encoder not inverted