Lenze 8400 motec - Manual (Page 262)

8 Basic functions
262 Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
8 Basic functions
This chapter describes both basic functions " Parameter change-over " and " Holding brake control ".
• The parameter change-over provides a change-over for up to 16 freely selectable parameters
between two sets with different parameter values.
• The holding brake control serves to control the holding brake with low rate of wear as a function
of the speed setpoint and various other internal digital control signals.