Lenze 8400 motec - Manual (Page 207)

Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05 207
7 Technology applications
7.2 TA "Actuating drive speed"
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
bFailReset
BOOL
C00701/2
Reset error message
In the Lenze setting this input is connected to the digital input controller enable so
that a possibly existing error message is reset together with the controller enable (if
the cause for the fault is eliminated).
TRUE The current fault is reset, if the cause for the fault is eliminated.
• If the fault still exists, the error status remains unchanged.
bSetQuickstop
BOOL
C00701/3
Enable quick stop (QSP)
• Also see device command " Activate/deactivate quick stop ".
TRUE Activate quick stop
• Motor control is decoupled from the setpoint selection and,
within the deceleration time parameterised in C00105 , the motor
is brought to a standstill (n
act
= 0).
• The motor is kept at a standstill during closed-loop operation.
• A pulse inhibit (CINH) is set if the auto-DCB function has been
activated via C00019 .
FALSE Deactivate quick stop
• The quick stop is deactivated if no other source for the quick stop
is active.
• C00159 displays a bit code of active sources/causes for the quick
stop.
bSetDCBrake
BOOL
C00701/4
Manual DC-injection braking (DCB)
• Detailed information on DC-injection braking is provided in the motor control
chapter, subchapter " DC-injection braking ".

Note!
Holding braking is not possible when this braking mode is used!
Use the basic " Holding brake control " function for controlling the holding brake with
a low rate of wear.
FALSE Deactivate DC-injection braking.
TRUE Activate DC-injection braking, i.e. the drive is brought to a standstill
by means of DC-injection braking.
• The braking effect stops when the rotor is at standstill.
• After the hold time ( C00107 ) has expired, the controller sets the
pulse inhibit (CINH).
Fail-safe selection of the direction of rotation in connection with quick stop
• In control mode "Terminals 16", both inputs are connected to the digital terminals DI3 and DI4.
• For a detailed functional description see FB L_RLQ .
bRLQCw
BOOL
C00701/17
Activate clockwise rotation (fail-safe)
FALSE Quick stop
TRUE CW rotation
bRLQCcw
BOOL
C00701/18
Activate counter-clockwise rotation (fail-safe)
FALSE Quick stop
TRUE Counter-clockwise rotation
Identifier
Data type
Configuration parameters
Information/possible settings