Lenze 8400 motec - Manual (Page 397)

Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05 397
11 Parameter reference
11.2 Parameter list | C00803
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00803
C00804
C00805
C00806
Parameter | Name:
C00803 | L_MPot_1: Deceleration time
Data type: UNSIGNED_16
Index: 23772 d = 5CDC h
The L_MPot_1 FB: Deceleration time of the motor potentiometer function
Setting range (min. value | unit | max. value) Lenze setting
0.1 s 999.9 10.0 s
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 10
Parameter | Name:
C00804 | L_MPot_1: Inactive fct.
Data type: UNSIGNED_8
Index: 23771 d = 5CDB h
The L_MPot_1 FB: Selection of the response if the motor potentiometer is deactivated via input bInAct
Selection list (Lenze setting printed in bold) Info
0 Retain value Keep output value
1 Deceleration to 0 Deceleration via ramp to 0
2 Deceleration to lower limit Deceleration via ramp to the lower limit ( C00801 )
3 Without ramp to 0 Step change to 0
4 Without ramp to lower limit Jump to lower limit ( C00800 )
5 Acceleration to upper limit Acceleration via ramp to upper limit ( C00800 )
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00805 | L_MPot_1: Init fct.
Data type: UNSIGNED_8
Index: 23770 d = 5CDA h
The L_MPot_1 FB: Selection of the response at device switch-on
Selection list (Lenze setting printed in bold)
0 Load last value
1 Load lower limit
2 Load 0
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00806 | L_MPot_1: Use
Data type: UNSIGNED_8
Index: 23769
d
= 5CD9
h
The L_MPot_1 FB: Use of the motor potentiometer
Selection list (Lenze setting printed in bold) Info
0 No The motor potentiometer is not used.
• The analog value applied to the nIn_a input is looped
through without any changes to the nOut_a output.
1 Yes The motor potentiometer is used.
• The analog value applied at the nIn_a input is led via
the motor potentiometer and provided at the nOut_a
output.
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1