Lenze 8400 motec - Manual (Page 201)

Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05 201
7 Technology applications
7.2 TA "Actuating drive speed"
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7.2 TA "Actuating drive speed"
Features
• Pre-configured control modes for terminals and bus control (with predefined process data
connection to the fieldbus)
• Free configuration of input and output signals
• Offset and gain of the main setpoint (if defined via analog input)
• Up to 3 fixed setpoint for speed
• Adjustable setpoint ramp times
• Linear or S-shaped ramp type
• Automatic holding brake control
• Quick stop (QSP) with adjustable ramp time
• Connectable motor potentiometer function (as alternative setpoint source)
• Connectable process controller (PID controller) with various operating modes
• Load monitoring
• Implemented and freely available "GeneralPurpose" functions:
Counter, binary delay element, binary logic, analog comparison
• Integration of encoder feedback
Input/output interface
The application features an input interface for the connection of the signal sources (e.g. main
setpoint) as well as an output interface for the control of output terminals and output ports.
Parameter
The setting/parameterisation of internal functions, the selection of setpoints and the display of
actual values is executed via parameters. A re-configuration of the interfaces is also possible via the
corresponding configuration parameters.
Related topics:
 Commissioning of the "Actuating drive speed" technology application ( 34)