Lenze 8400 motec - Manual (Page 213)

Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05 213
7 Technology applications
7.2 TA "Actuating drive speed"
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Bit 4 FreeStatusBit4 Free status bit 4 (configurable in C00621/10 )
In the Lenze setting pre-assigned with LA_NCtrl_bSpeedActEqSet signal:
1 ≡ Actual speed value has reached the setpoint within one hysteresis band
Bit 5 FreeStatusBit5 Free status bit 5 (configurable in C00621/11 )
In the Lenze setting pre-assigned with LA_NCtrl_bNActCompare signal:
• In case of the "Open loop" operation:
1 ≡ Speed setpoint < comparison value ( C00024 )
• For "Closed loop" operation:
1 ≡ actual speed value < comparison value ( C00024 )
Bit 6 ActSpeedIsZero 1 ≡ Current speed is 0
Bit 7 ControllerInhibit 1 ≡ Controller inhibited (controller inhibit is active)
Bit 8 StatusCodeBit0 Bit coded display of the active device status
 Device state machine and device states (see table [4-1] )
Bit 9 StatusCodeBit1
Bit 10 StatusCodeBit2
Bit 11 StatusCodeBit3
Bit 12 Warning
1 ≡ A warning exists.
Bit 13 Trouble 1 ≡ Controller is in the " Trouble " device status
• E.g. if an overvoltage has occurred.
Bit 14 FreeStatusBit14 Free status bit 14 (configurable in C00621/12 )
In the Lenze setting pre-assigned with LA_NCtrl_bSpeedCcw signal:
0 ≡ Clockwise direction of rotation (Cw), 1 ≡ Counter-clockwise direction of
rotation (Ccw)
Bit 15 FreeStatusBit15 Free status bit 15 (configurable in C00621/13 )
In Lenze setting pre-assigned with LA_NCtrl_bDriveReady signal:
1 ≡ Drive controller is ready for operation
Bit Name Status