Lenze 8400 motec - Manual (Page 414)

11 Parameter reference
11.2 Parameter list | C01206
414 Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C01206
C01350
Parameter | Name:
C01206 | Axis data: Mounting direction
Data type: UNSIGNED_8
Index: 23369 d = 5B49 h
From version 02.00.00
Inversion for mirrored motor and encoder mounting
Selection list
0 not inverted
1 inverted
Subcodes Lenze setting Info
C01206/1 0: Not inverted Motor mounting direction
• Setting for motor mounting turned by 180°.
C01206/2 0: Not inverted Position encoder mounting direction
• Setting for position encoder system mounting turned
by 180°.
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C01350 | ACDrive: Drive mode
Data type: UNSIGNED_8
Index: 23225 d = 5AB9 h
From version 04.01.00
This parameter is set by the EtherNet/IP™ Communication Unit and should not be written by the user.
• Detailed information on the "AC Drive Profile" can be found in the EtherNet/IP™ communication manual.
Selection list
1 Speed mode
3 Torque mode
Subcodes Lenze setting Info
C01350/1 1: Speed mode ACDrive: Drive mode
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1