Configuring the list by means of parameterisation, 8basic functions – Lenze 8400 motec User Manual
Page 266
8
Basic functions
8.1
Parameter change-over
266
Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Importing/exporting the list
For cross-device reuse of the configured WriteParamList, you can click on the Export list and Import
list buttons to save the parameter selection as an *.epc file and then to re-import the saved *.epc file
into another drive controller 8400.
8.1.2
Configuring the list by means of parameterisation
The following application example shows the necessary procedure for configuring the list without
using the »Engineer« parameterisation dialog.
Task:
The parameters
to
are to be written.
Compiling the parameter list
In
, specify the above-named parameters in the <Code>,<Subcode> format:
•
= 12.000
•
= 26.001
•
= 27.001
•
= 222.000
•
= 223.000
•
= 224.000
•
Entering values for the parameters (value set 1)
In
, specify the values to be used to describe the selected parameters. The values are
entered according to the scaling format/scaling factor of the respective parameter.
•
= <value> for list entry 1 (in our example: for parameter
•
= <value> for list entry 2 (in our example: for parameter
•
= <value> for list entry 3 (in our example: for parameter
• etc.
These values are used for writing if the bSelectWriteValue_1 input is not assigned or set to FALSE.
Entering further different values for the parameters (value set 2)
If required, you can set another set with values in the same manner in
which serve to
write the parameters.
Note!
Gaps in the parameter list (setting = 0.000) are permissible and are skipped in the
process.
Invalid parameter entries are not accepted when being entered.