Lenze 8400 motec - Manual (Page 313)

Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05 313
9 Diagnostics & error management
9.8 Error messages of the operating system
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
PS04: Par. set device incompatible [xx.0144.00004]
PS31: Ident. error [xx.0144.00031]
dF01: Internal error 01 [xx.0145.00001]
dF02: Internal error 02 [xx.0145.00002]
dF03: Internal error 03 [xx.0145.00003]
Response (Lenze setting printed in bold)
 No Reaction  Fault  Trouble  WarningLocked
Cause Remedy
The parameter set saved to the memory module is in-
compatible to the standard device.
• Incompatibility of the parameter set is e.g. caused if
the parameter set in the memory module has a higher
version than the standard device.
When the memory modules are exchanged, observe the
downward compatibility:
• OK: motec V1.0 to motec > V1.0
• Not OK: motec V2.0 to motec < V2.0
Response (Lenze setting printed in bold)
 No Reaction  Fault  Trouble  WarningLocked
Cause Remedy
Incompatible or unknown HW components have been
found.
• Check which HW components are faulty ( C00203/x :
Product type code).
• Check connection between communication unit and
drive unit regarding for contact problems.
• Check temperature range of the device at the start.
• Replace communication unit.
• Check whether a software update at Lenze is possible.
Response (Lenze setting printed in bold)
 No Reaction  Fault  Trouble  WarningLocked
Cause Remedy
Device error • Reduce switching frequency ( C00018 ) to 4 kHz.
• Please contact Lenze if the problem occurs again.
Response (Lenze setting printed in bold)
 No Reaction  Fault  Trouble  WarningLocked
Cause Remedy
Device error • Mains switching or restart of the controller, respec-
tively.
• Please contact Lenze if the problem occurs again.
Response (Lenze setting printed in bold)
 No Reaction  Fault  Trouble  WarningLocked
Cause Remedy
Device error • Mains switching or restart of the controller, respec-
tively.
• Please contact Lenze if the problem occurs again.