3 commissioning, Commissioning, 3commissioning – Lenze 8400 motec User Manual
Page 30
3
Commissioning
30
Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3
Commissioning
The 8400 motec controller is commissioned in one of the following ways:
• Commissioning via PC / »Engineer«
• The »Engineer« provides a comfortable access to all parameters of the 8400 motec controller
and hence full flexibility in the commissioning process.
• Commissioning with diagnosis terminal
(If only a few parameters have to be adapted)
• Commissioning via the DIP switches/potentiometers at the 8400 motec
(for simple applications)
This chapter provides information on how to commission the 8400 motec using the »Engineer«.
Information on how to commission the 8400 motec via the DIP switches/
potentiometers can be found in the mounting instructions!
Information on how to commission the 8400 motec using the diagnosis terminal can be
found in the hardware manual!