Lenze 8400 motec - Manual (Page 200)

7 Technology applications
7.1 Selection of the technology application and the control mode
200 Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7.1 Selection of the technology application and the control mode
The technology application to be used is selected in C00005 .
• You can select the technology application in the »Engineer« on the Application parameter tab
via the Application list field:
Various control modes can be selected for each application in C00007 . The selection of the control
mode determines the way the technology application is controlled, e.g. via terminals or via a
fieldbus.
• You can select the control mode in the »Engineer« on the Application parameter tab via the
Control mode list field:

Tip!
You can infer the pre-configured assignment of the input/output terminals and ports for
each control mode from the description of the corresponding technology application:
TA "Actuating drive speed":
Terminal assignment of the control modes ( 214)
TA "Switch-off positioning": Terminal assignment of the control modes ( 246)
Detailed information on the individual configuration of the input/output terminals can be
found in the description of the I/O terminals in the subchapter " User-defined terminal
assignment ". ( 191)