Lenze 8400 motec - Manual (Page 18)

2 Introduction: Parameterising the controller
2.1 Integrated technology applications
18 Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2.1 Integrated technology applications
The following technology applications integrated in the drive controller 8400 motec provide the
main signal flow for the implementation of a general or a special drive solution:
Technology application "Actuating drive speed"
This preset technology application serves to solve speed-controlled drive tasks, e.g.
conveyor drives (interconnected), extruders, test benches, vibrators, travelling drives,
presses, machining systems, metering units.
technology application "Actuating drive speed (AC Drive Profile)"
This technology application available
from version 04.01.00 provides a speed and
torque control by means of "AC Drive Profile". For this purpose, the Communication
Unit EtherNet/IP™ is required.
"Switch-off positioning" technology application
This technology application available
from version 05.00.00 is used to solve speed-
controlled drive tasks which require a pre-switch off or stopping at certain positions,
e.g. roller conveyors and conveying belts. The pre-switch off is implemented by con-
necting switch-off sensors.

Detailed information on each technology application can be found in the main chapter
entitled " Technology applications ". ( 199)