Lenze 8400 motec - Manual (Page 26)

2 Introduction: Parameterising the controller
2.3 General notes on parameters
26 Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2.3.3 User menu for quick access to frequently used parameters
When a system is installed, parameters must be changed time and again until the system runs sat-
isfactorily. The user menu of the controller contains a selection of frequently used parameters to be
able to access and change these parameters quickly:

Tip!
The user menu can be freely configured in
C00517 .
In the »Engineer«, you can configure the user menu comfortably via the User menu tab (see
»Engineer« online help).
Parameter Name Lenze setting
C00051 MCTRL: Actual speed value -
C00053 DC-bus voltage -
C00054 Motor current -
C00061 Heatsink temperature -
C00137 Device status -
C00166/3 Mess. - status det. error -
C00011 Appl.: Reference speed 1500 rpm
C00039/1 Fixed setpoint 1 40.0 %
C00039/2 Fixed setpoint 2 60.0 %
C00012 Acceleration time - main setpoint 2.0 s
C00013 Deceleration time - main setpoint 2.0 s
C00015 VFC: V/f base frequency 50 Hz
C00016 VFC: Vmin boost 0.0 %
C00022 Imax in motor mode depending on the device power
C00120 Setting of motor overload (I 2 xt) 100.00 %
C00087 Rated motor speed 1460 rpm
C00099 Firmware version -
C00200 Firmware product type -
C00105 Decel. time - quick stop 5.0 s
C00173 Mains voltage 0: "3ph 400V"
Highlighted in grey = display parameter