Lenze 8400 motec - Manual (Page 310)

9 Diagnostics & error management
9.8 Error messages of the operating system
310 Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Smr3: Module timeout - one or more of PDOs timeout [xx.0127.00005]
Smr4: SDO access failure [xx.0127.00006]
CE0F: MCI control word [xx.0127.00015]
CE4: CAN bus off [xx.0131.00000]
CA06: CAN CRC error [xx.0131.00002]
Response (Lenze setting printed in bold)
 No Reaction  Fault  Trouble  WarningLocked
Cause Remedy
Communication Unit: A timeout has occurred for one or
several PDOs
• Increase timeout in C01503/1 .
• Mains switching or restart of the controller, respec-
tively.
• Check correct identification of the Communication
Unit in C00203/3 .
• Replace Communication Unit.
• Please contact Lenze if the problem occurs again.
Response (Lenze setting printed in bold)
 No Reaction  Fault  Trouble  WarningLocked
Cause Remedy
An error has occurred during SDO access • Mains switching or restart of the controller, respec-
tively.
• Please contact Lenze if the problem occurs again.
Response (Lenze setting printed in bold) Setting: C00594/2 ( Adjustable response)
 No Reaction  Fault  Trouble  WarningLocked
Cause Remedy
Bit 14 ("SetFail") of the wMciCtrl control word of the
LS_DriveInterface system block has been set.
Trace back signal source on the bus (e.g. PROFIBUS) that
sets bit 14 ("SetFail").
Response (Lenze setting printed in bold) Setting: C00592/2 ( Adjustable response)
 No Reaction  Fault  Trouble  WarningLocked
Cause Remedy
CAN interface: "Bus-Off" state
• Received too many faulty telegrams.
• Damaged cable (e.g. loose contact).
• Two nodes with the same ID.
• Check wiring and bus terminating resistor.
• Set identical baud rate for each bus node.
• Assign different IDs to nodes.
• Eliminate electrical interference (e.g. EMC).
Response (Lenze setting printed in bold) Setting: C00592/1 ( Adjustable response)
 No Reaction  Fault  Trouble  WarningLocked
Cause Remedy
CAN interface: a faulty CAN telegram has been detected. • Check wiring and bus terminating resistor.
• Eliminate electrical interference (e.g. EMC).