Lenze 8400 motec - Manual (Page 385)

Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05 385
11 Parameter reference
11.2 Parameter list | C00586
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00586
C00594
C00597
Parameter | Name:
C00586 | Resp. to encoder open circuit
Data type: UNSIGNED_8
Index: 23989 d = 5DB5 h
From version 02.00.00
Response to encoder feedback system failure or encoder feedback system track failure due to open circuit
Note:
Despite the encoder error, monitoring is not activated if the setpoint is lower than or equals 40 Hz.
Selection list
(Lenze setting printed in bold)
0 No Reaction
1 Fault
4 WarningLocked
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00594 | Resp. to control word error
Data type: UNSIGNED_8
Index: 23981 d = 5DAD h
Configuration of device control monitoring
Selection list
0 No Reaction
1 Fault
2 Trouble
4 WarningLocked
Subcodes Lenze setting Info
C00594/1 0: No Reaction Response if error bit 14 in the CAN control word is set.
C00594/2 1: Fault Response if error bit 14 in the MCI control word is set.
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00597 | Resp. to LP1 motor phase fault
Data type: UNSIGNED_8
Index: 23978
d
= 5DAA
h
Response to motor phase failure
• Online testing includes the monitoring of the three motor phases during operation (motor rotates).
• Static testing means testing before the holding brake is released.
Selection list (Lenze setting printed in bold)
0 No Reaction
1 Fault
4 WarningLocked
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1